Clearances |
A minimum of 2 mm clearance should be given to the bottom surface except for a
10 mm diameter area around the bottom mounting holes. Figure 13 shows a 2 mm
clearance requirements (see 1 figure 13). For proper cooling it is suggested
that a clearance of 6 mm be provided under the drive and on top of the file. |
There should be 7 mm of clearance between drives that are mounted with their
top sides facing each other. |
 |
 |
Mounting |
The drive can be mounted with any surface facing down. The drive has both side and bottom mounting holes.
The maximum allowable penetration of the mounting screws is 3.8mm. The torque applied to the mounting screws must be 0.45 Newton meters +/-0.1
Newton meters. |
Note: Except for the isolated mounting holes the disk enclosure is
not at ground potential. |
| |
