Travelstar 18GT
Jumper settings |
Models: DARA-215000 and 218000 |
|
Drive address setting |
| A jumper is available at the interface connector to determine the drive address. |
| |
| Note: When cable selection is used (Jumper Pos 3 selected), the
drive address depends on the condition of pin 28 of the AT interface
cable. In the case when pin 28 is ground or low, the drive is a
master. If pin 28 is open or high level, the drive is a slave. |
 |
| |
Shipping default settings |
| The default setting of jumper at shipment is No Jumper (Master). |
|
|
